internetworker
MIS
Hi,
I have two cases(sites), with a RT 2600 with ethernet, serial and bri on it.Also i have a Switch 2950 and 15 workstations on it. 20 days after the first installation i tried to connect another workstation on switch...but i couldn't. The first 15 workstations were working normally on the network, but i couldn't connect anything on the other ports.When i unplugged one cable of the existing ones on the switch the led was continually on.I couldn't telnet or ping on it(I couldn't use console).Of course when i turn off/on the switch everything were ok.10,about, days after the same thing happened.
No "spanning-tree portfast" is configured on switch,no other switch/hub on it.
The other sites with same Routers but Switches 2912/2924 have the same excactly configuration on them but i never got similar problem.
I just want to know if anyone has met this problem before with new 2950 switches or advise me where to look for sth or any idea about a solution?
I have two cases(sites), with a RT 2600 with ethernet, serial and bri on it.Also i have a Switch 2950 and 15 workstations on it. 20 days after the first installation i tried to connect another workstation on switch...but i couldn't. The first 15 workstations were working normally on the network, but i couldn't connect anything on the other ports.When i unplugged one cable of the existing ones on the switch the led was continually on.I couldn't telnet or ping on it(I couldn't use console).Of course when i turn off/on the switch everything were ok.10,about, days after the same thing happened.
No "spanning-tree portfast" is configured on switch,no other switch/hub on it.
The other sites with same Routers but Switches 2912/2924 have the same excactly configuration on them but i never got similar problem.
I just want to know if anyone has met this problem before with new 2950 switches or advise me where to look for sth or any idea about a solution?