Hi.I need to know what we need to configure on an IOS routers & switches to be able to be managed by Ciscoworks applications (RME, Campus & CiscoView)...i can see the devices, but when i check their attributes in RME show attribute devices , it gives me (no checked yet)...
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations SkipVought on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Cisco Router IOS needed configuration for CW2000 1
- Thread starter michoco
- Start date
-
1
- #2
You need to go to the RME-->Admin-->Inventory--> change Device attributes
and pick your devices then attributes to chnge (you want Telnet and enable passwords) Fill in all relevant (depending on you device configs). clicking finish on each page.
I have never found CW2K automatically recheck attributes so run a manual check with RME-->Admin-->Inventory--> Check Device attributes.
and then look in RME-->Admin-->Inventory--> View check results.
Up to the latest ver it has been the case that ANI discovery only passes snmp info to rme. you then need to add these device attributes for all new devices.
and pick your devices then attributes to chnge (you want Telnet and enable passwords) Fill in all relevant (depending on you device configs). clicking finish on each page.
I have never found CW2K automatically recheck attributes so run a manual check with RME-->Admin-->Inventory--> Check Device attributes.
and then look in RME-->Admin-->Inventory--> View check results.
Up to the latest ver it has been the case that ANI discovery only passes snmp info to rme. you then need to add these device attributes for all new devices.
- Status
Similar threads
- Locked
- Question
- Locked
- Question