This is my very first configuration of a Cisco Pix firewall. My problems is I'm unable to access exchange using Outlook Express however I can access it using OWA. My question is how do you view the running config on a Cisco Pix? I would like to view this to ensure the POP3 port is available. Can somone point me in the right direction? Keep in mind I'm a layman when it comes to Cisco products. Thanks for any assistance rendered.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Cisco Pix ??????
- Thread starter piwadmin
- Start date
jcoburn142
MIS
The command used to view a current config: write terminal
piwadmin,
Issuing a "write terminal" or "wr t" (shorthand) will show the config, but make sure you are in enable mode.
You should have an access-list statement that looks like:
access-list 110 permit tcp any host a.a.a.a eq pop3
where a.a.a.a is the IP address of your exchange server.
Don't forget that you also need to apply the access-list to an interface. You should have a statement:
access-group 100 in interface outside
Here are some links on Cisco's page to get you started:
Issuing a "write terminal" or "wr t" (shorthand) will show the config, but make sure you are in enable mode.
You should have an access-list statement that looks like:
access-list 110 permit tcp any host a.a.a.a eq pop3
where a.a.a.a is the IP address of your exchange server.
Don't forget that you also need to apply the access-list to an interface. You should have a statement:
access-group 100 in interface outside
Here are some links on Cisco's page to get you started:
- Status