Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Cisco PIX 525 is not allowing DHCP address to be applied to router

Status
Not open for further replies.

brownmab53

Technical User
Dec 18, 2014
6
US
Hello,

I currently have a Cisco PIX 525 firewall running version 7.0(1) and ASDM 5.0(4). It is running in transparent mode, and it is connected between my Time Warner Cable [TWC] modema and F0/0 on my Cisco 3660 router. When I reload the router, the router cannot obtain the DHCP IP address from TWC. I have to disconnect the LAN cable from the PIX outside interface and connect it directly to the F0/0 on the router, allow the DHCP address to be obtained, and then reconnect the TWC modem back to the outside interface. About every 24 hours, I ahve to continue to the the same process when the router's DHCP lease ends. I know there are other ways around it (ie. configuring the PIX in router mode, getting rid of the PIX and using the firewall ability in the router's IOS), but this is the hardware configuration I would like to use. I am unfamiliar with setting up a PIX / Firewall, and I would like to use this as one of my many learning experiences. What IOS command sequence, or ASDM configuration screen(s) settings, would I use to allow DHCP IP and DNS requests and addresses to pass through to the inside interface and ultimately the router?

Thanks,
brownamb53
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top