Hi
I made the VPN configuration betwen Cisco 850 and linksys WRV210 and i missed to add the access-list 101 to the configuration and the WRV210 went unresponsive, is that normal ???
now the real question is when i applied ...
access-list 101 permit ip 172.16.x.0 0.0.0.255 172.16.x2.0 0.0.0.255
i see traffic comming in but reaching their destination and i can not send anything over the VPN from either side does it mean that i need ip route since my crypto map is connected to FE4 and not the vlan 1 ...
i can se that i have pkts decaps, decrypt ... but nothing in packets encaps and when i use traceroute i see that the local ip address on the other end of the tunnel, it send the data out to the router on the internet then instead out on the VPN tunnel from cisco 850 ...
MaT
I made the VPN configuration betwen Cisco 850 and linksys WRV210 and i missed to add the access-list 101 to the configuration and the WRV210 went unresponsive, is that normal ???
now the real question is when i applied ...
access-list 101 permit ip 172.16.x.0 0.0.0.255 172.16.x2.0 0.0.0.255
i see traffic comming in but reaching their destination and i can not send anything over the VPN from either side does it mean that i need ip route since my crypto map is connected to FE4 and not the vlan 1 ...
i can se that i have pkts decaps, decrypt ... but nothing in packets encaps and when i use traceroute i see that the local ip address on the other end of the tunnel, it send the data out to the router on the internet then instead out on the VPN tunnel from cisco 850 ...
MaT