Cisco CSS port trunking question?

[VOIPaintEASY]

Can I trunk or bind 2 ports on the same VLAN in a Cisco CSS to aggregate 2 100MB ports for 200MB?

 

[burtsbees]

If it supports port-channel
Try the commands, and if they show up, then you should be able to.
Just go into the cli and get to the
switch(config-if)#
prompt and enter a ?

Burt

 

[VOIPaintEASY]

This is what I get.

CSS11050(config-if[e8])# a?
acl Enter ACL configuration mode
admin-shutdown Administratively shut down an interface
alias Create a command alias
archive Archive commands

*** Aliases ***
aca-load @script play service-load

CSS11050(config-if[e8])#

 

[burtsbees]

I meant just the "?", not "a?"

Burt