blackburn2413
IS-IT--Management
So I am trying to use my Cisco cme setup int my lab with my new magicjack. Here is a little background story for everyone. The magicjack works with a regular phone connected and the cisco phones work fine if they are connected to a regular pots phone line...
My problem is that when I dial on my cisco phones now it matches a dialpeer and "rings out" at which point all I get is a dialtone... Here is a funny tidbit. If I use the magicjack dialer on my PC at that point when I have a dialtone- I can hear the call on the cisco phone. It seems that the cisco phone matching a dial peer is connecting my phone to the open phone line, but not actually dialing out... Also trying to dial a second time when I get the dialtone does nothing, it's like digits dialed on the cisco phones are not being passed to the phone line of the magicjack...
I have attached my CME router config for reference.
Any Ideas?
My problem is that when I dial on my cisco phones now it matches a dialpeer and "rings out" at which point all I get is a dialtone... Here is a funny tidbit. If I use the magicjack dialer on my PC at that point when I have a dialtone- I can hear the call on the cisco phone. It seems that the cisco phone matching a dial peer is connecting my phone to the open phone line, but not actually dialing out... Also trying to dial a second time when I get the dialtone does nothing, it's like digits dialed on the cisco phones are not being passed to the phone line of the magicjack...
I have attached my CME router config for reference.
Any Ideas?