I ham trying to point my PIX 515e to a new ACS server. When I do that, the users are not able to authenticate. Error 403. The PIX and the ACS server are communicating with each other. However, I did notice that the failed authentications (or anything for that matter) are not being written to the reports in ACS. That could be the problem, but I am not too sure. Has anyone run into this problem before? Do you know how to fix it?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations gkittelson on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Cisco ACS 3.3(2) authentication problem
- Thread starter techalum
- Start date
Supergrrover
IS-IT--Management
Do you know that the new ACS is opertaional?
Can you post a config?
You might want to move this over the pix forum
Brent
Systems Engineer / Consultant
CCNP, CCSP
Can you post a config?
You might want to move this over the pix forum
Brent
Systems Engineer / Consultant
CCNP, CCSP
- Status
Similar threads
- Locked
- Question
- Locked
- Question