Cisco access lists

[shthco]

Hello everyone
I'm some what new to configuring Cisco routers. I was wandering if it is possible to configure two access lists for one interface. I'm wanting to setup an access list for imcoming traffic and outgoing traffic. Any advice or suggestions, would be greatly appreiciated.

Thank you.

 

[StarTAC]

yes, u can have to separate access lists to define traffic in two opposite directions.. u can't, however, have the 2 separate access lists defining traffic in the same direction.. u might as well just add your rules to that one list..

anyway, configure your lists, and apply them to your interface like so:

int s0
ip access-group 100 in
ip access-group 101 out

good luck..