Hello,
I have about 250 Cisco 827's that I am responsible for upgrading to the new XH load. (Switching to the XH load so get the routers to reconnect after an ATM drop) All of these router are base line routers. All are currently running the YB3 load. What I am noticing is that this new load is crashing on some of the routers but not all. They all have the same hardward (8meg flash and 16meg RAM). CCO says that 8/16 is fine to run this load, but I have found that if I have 24 megs of RAM that the routers stablize. I have TAC case open with Cisco, but I am wondering if anyone else has seen this issue and has found a common bond that perhaps I am missing somewhere. Any feedback is appreciated. Serenity
jyates@golden.net
CCNA, MCSE (NT Track), A+, Network+, SCO CUSA, CNA
I have about 250 Cisco 827's that I am responsible for upgrading to the new XH load. (Switching to the XH load so get the routers to reconnect after an ATM drop) All of these router are base line routers. All are currently running the YB3 load. What I am noticing is that this new load is crashing on some of the routers but not all. They all have the same hardward (8meg flash and 16meg RAM). CCO says that 8/16 is fine to run this load, but I have found that if I have 24 megs of RAM that the routers stablize. I have TAC case open with Cisco, but I am wondering if anyone else has seen this issue and has found a common bond that perhaps I am missing somewhere. Any feedback is appreciated. Serenity
jyates@golden.net
CCNA, MCSE (NT Track), A+, Network+, SCO CUSA, CNA
