Hi all,
Finally managed to get my Cisco 803 router up and running and is now working correctly'ish with the PC.
It dials out correctly and I can ping servers etc. with good results and browse's the web fine - The only difference is that the pages were loading about 25% quicker when I was using my ISDN TA at 64K ISDN I would have thought the router 64k connection would have been the same speed if not a little quicker??
My only thoughts are that compression (Which is supported by my ISP) is not enabled on the router - it was shown active when using the TA under windows.
How Can I check that Compression is enabled on the router or what is the IOS or Telnet command to enable it?
I also cannot get the router to use both Channels - I checked that I had the only use one channel option in Cisco Fast setup disabled so I assumed it would automatically use both channels at 128k as supported by the ISP?
The speed of the browsing is my main concern tho.....any ideas??
Thanks
D.
Finally managed to get my Cisco 803 router up and running and is now working correctly'ish with the PC.
It dials out correctly and I can ping servers etc. with good results and browse's the web fine - The only difference is that the pages were loading about 25% quicker when I was using my ISDN TA at 64K ISDN I would have thought the router 64k connection would have been the same speed if not a little quicker??
My only thoughts are that compression (Which is supported by my ISP) is not enabled on the router - it was shown active when using the TA under windows.
How Can I check that Compression is enabled on the router or what is the IOS or Telnet command to enable it?
I also cannot get the router to use both Channels - I checked that I had the only use one channel option in Cisco Fast setup disabled so I assumed it would automatically use both channels at 128k as supported by the ISP?
The speed of the browsing is my main concern tho.....any ideas??
Thanks
D.
