Cisco 6509 VLAN configuration

[Atlantauk]

Need to configure a 6509 running IOS to talk to a Netgear 7326POE switch. The netgear has two vlans. Vlan 10 is tagged, vlan 30 is untagged.

When vlan 30 traffic leaves the Netgear it is tagged as Vlan 30 - Vlan 10 traffic is, of course, already tagged.

The netgear box is attached to the 6509 on Ethernet port 0/1.

I guess I need to ensure that when traffic is heading back to the netgear box from the 6509 that it is correctly tagged. So I assume that as the netgear box has a statement that taggs the untagged vlan 30 trafic to vlan 30 as its heads to the cisco box I need the 6509 to do the same thing in the opposite direction.

At the Cisco end I need to associate IP subnets to each Vlan (Vlan 10 is 192.168.10.1 and vlan 30 is 192.168.30.1) and assign an iphelper to each subnet 1 pointing to 192.168.50.50.

I need the cisco box to route between all three networks.

Can anyone point to a config file that will acheive that on the 6509.

Thx.

 

[chieftan999]

If the VLAN is tagged does that mean you are using 802.1Q trunking across the link?

If you are then the config differs on the 6509 chassis.

What version of Supervisor are you using?



Reamin positive. The affect on those around you will amaze.