Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Cisco 3845 PRI to Harris 20/20 pbx

Status
Not open for further replies.

jschreiner

Vendor
Feb 27, 2012
12
US
I am trying to get a Harris 20/20 pbx to talk to a Cisco 3845 properly. I have them configured and dial peers setup, but the Harris apparently is issuing a disconnect as soon as they connect.

Harris is set to DMS100 and Cisco is set to primary-DMS100. ISDN status shows Layer one and two up. Debugging shows the digits being passed then the Harris pbx issues a disconnect.

Any ideas or thoughts on what might be needed on the Cisco or Harris configurations, or any working examples?
 
Try /ans after the digits in the incoming collect and route that
the cisco trunk group is pointed to.

example: XXXXX /ans = Sta
or XXX XXX XXXX /rem 1,6 /ans =sta

X is the numbers being sent from the Cisco switch.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top