Cisco 3845 level 15 privilege show run command shows nothing

[centoffsuper]

All of the sudden my router is not showing the running config. I have verified that I am at level 15 when I try. Any ideas? Thanks.

 

[stubnski]

Hi,

What method are you using for authentication - local, AAA? Can you do other show commands - show version? Can you still configure the router?

 

[centoffsuper]

yes i can do most everything else. when i do a show tech-support the running-config is also empty there. almost like it was erased but the startup-config is still in place. when i log into the router i have always used telnet with the exception of a few times where i would console. i used the secret password then verify level 15..thanks!

 

[stubnski]

Can you view the startup config? Have there been any recent changes? What happens when you copy the startup config to the running config (after you verified you can view the startup)? Are you the only person with access to the switch? If not the only person, can others see the running config?

Also, you should configure ssh on your switch.

 

[7740090]

Can you WR memory on the switch. I had a issue like this before. Were I could not see the running config, but I also could not write memory. It was a software bug. My fix was new version.

 

[burtsbees]

Post a sh ver

10 ? "TIMMAY!!!"
20 goto 10
run
TIMMAY!!!
TIMMAY!!!
TIMMAY!!!
TIMMAY!!!
TIMMAY!!!
TIMMAY!!!
TIMMAY!!!
TIMMAY!!!
TIMMAY!!!
TIMMAY!!!
TIMMAY!!!
TIMMAY!!!
TIMMAY!!!
TIMMAY!!!
TIMMAY!!!
TIMMAY!!!
TIMMAY!!!
TIMMAY!!!
TIMMAY!!!
TIMMAY!!!
TIMMAY!!!
TIMMAY!!!
TIMMAY!!!
TIMMAY!!!
TIMMAY!!!
TIMMAY!!!
TIMMAY!!!
TIMMAY!!!
TIMMAY!

 

[centoffsuper]

Thanks everyone for your comments. Not sure what happened but the running config is showing up again...weird.