Cisco 3750 stack configuration

[pedro965]

Hi to all, I'm Pietro and I'm a new user of this forum.
I work with network and lately we are trying to use 6 cisco 3750 stackable. The problem is that I configured the switches one by one and then I connected them with stack cables. When i use this command "show switch stack-ports" I can see that the ports are ok. When I use "show switch neighbors" command everything is ok. Now how I have to continue to set up the stack switch? Thank you for your answers

 

[vipergg]

Whats the question ????????????

 

[vipergg]

If you are new to the switches your best bet is to go to cisco.com and search for the configuration guides for the 3750's and read thru it . Way too much to explain here. '

http://www.cisco.com/en/US/docs/swi...lease/12.2_50_se/configuration/guide/scg.html

 

[kcbell]

A good command is
show interface status

You will see all the ports on all the switches if you have 3 switchws; you should see Fa3/0/1 signifies that is the 1st port on the 3rd switch.

Another good command is
show vlan

then you will see the same vlan settings that you have in your network.
Yes, there is too much to talk about here...

 

[pedro965]

Thanks to all. I,ve read well the cisco guide and I found how to recovery password. The problem was that there was a password set by cisco but I did not know it!!So I changed it and configured the stack switch as I wanted.
Thanks