CISCO 3661 to NORTEL PBX

[glynnmsg]

I have a problem that I was hoping someone in the CISCO world could help me with. I have a Cisco 3616 at this time it has two t-1s from the local telephone company. I would like to eliminate them and just use a t-1 from a NORTEL opt 81c Rel 3 PBX. Has any one ever tried this ? Thanks in advance

 

[whykap]

r u trying to eliminate the router then and put the Circuits directly into the Nortel? Are they voice or data circuits?
I am not sure I understand your question. Can u be more detailed?

 

[glynnmsg]

We are trying to eliminate the telco circuits and use the nortel pbx. The CISCO device is used for remote access and dial out. We would like to have the T-1 from the PBX go into the CISCO. This way when they dial out they use the PBX. I hope this give you a little more info

 

[whykap]

Yes you should be able to do that. T1 x-over cables from the nortel to the router module and matching configuration should do it.
What type of module do the telco circuits terminate into the router?

 

[glynnmsg]

That I don't know. I would have to check with the network guy. All I know is there is a pri from the telcom terminate in the back of the unit. (I think that must be a t-1 card) Thanks again. I will let you know if I get this to work