CISCO 3660 doesnt support vlans

[nyingmeh]

My company has two Cisco 3660 routers with the same IOS 12.1(5)T one of them supports VLANs and the other doesnt seem to recorgnise any VLAN commands i really do not know what to do

I copied the IOS from the router which supports VLANS into the one which doesnt since both have the same version of IOS nothing chnged on the second router which doesnt sopport vlans

Please i need help on this as soon as posible
Thanks

 

[burtsbees]

What commands are you trying, and at what prompt?

Burt

 

[BuckWeet]

While it might be the same software level, it probably has different features.. Meaning one might have the enterprise software, while the other might just have IP software.

BuckWeet

 

[ADB100]

What modules are installed in each chassis? Can you post a show ver from each one?

Andy

 

[vipergg]

One probably has the 4 or 8 or 16 port hwic switch cards in them which would then allow you to create vlans . As long as you have at least ip plus IOS you can still do intervlan routing via a trunk link to a l2 switch where you could then break it out . Look at the back of the one that supports vlans and the one that does not , see if the one that supports it looks like it has a 4,8 or 16 port hwic card installed .

 

[nyingmeh]

This is what the result of the sh version command

SH VERSION
Cisco Internetwork Operating System Software
IOS (tm) 3600 Software (C3660-I-M), Version 12.1(5)T10, RELEASE SOFTWARE (fc2)
TAC Support:

http://www.cisco.com/tac

Copyright (c) 1986-2001 by cisco Systems, Inc.
Compiled Wed 08-Aug-01 05:47 by ccai
Image text-base: 0x60008960, data-base: 0x60A40000

ROM: System Bootstrap, Version 12.0(6r)T, RELEASE SOFTWARE (fc1)

Router uptime is 5 minutes
System returned to ROM by reload at 15:30:52 UTC Tue Jun 27 2006
System image file is "flash:c3660-i-mz.121-5.T10"

cisco c3660 (R527x) processor (revision C0) with 28672K/4096K bytes of memory.
Processor board ID JAC0542A0DZ
R527x CPU at 225Mhz, Implementation 40, Rev 10.0, 2048KB L2 Cache
Bridging software.
X.25 software, Version 3.0.0.


3660 Chassis type: ENTERPRISE
2 Ethernet/IEEE 802.3 interface(s)
1 FastEthernet/IEEE 802.3 interface(s)
configuration is 64 bits wide with parity disabled.
125K bytes of non-volatile configuration memory.
8192K bytes of processor board System flash (Read/Write)

Configuration register is 0x2102

 

[ADB100]

......and the other one...

 

[nyingmeh]

I dont have access to the other router sine its not in my building its going to take alot of time to get to it

 

[vipergg]

My guess is the one you showed here does not allow vlan creation , don't see any hwic switch cards. Bet the other one has them .