CISCO 3010X: Password Recovery

[xunil321]

Dear all,
in order to revover the lost password of a 3110X switch
we followed exactly the procedure described in Chapter 47 of this manual:

http://www.cisco.com/en/US/docs/switches/blades/3110/hardware/quick/guide/1800801.html

After releasing the MODE button we see these messages

"Password recovery mechanism is enabled. The system has been interrupted prior to

initializing the flash file system. The following commands will initialize the flash file system, and

finish loading the operating system software:

flash_init

boot

NOTE: In contrast to the manual we do NOT see the "load_helper" command here.

In the next step we initialized the flash filesystem by entering

SWITCH: flash_init

Because we could not load any helper file (load_helper: cmd not found) we displayed the
switch file system

SWITCH: dir flash:

and saw only 1 file called 'multiple-fs' and 1 directory called 'cbs31x0-universal-mz.122-52.SE' with this contents:

- info (file)

-html (directory)

But there is no 'config.txt' file at all!
Therefore we boot up the system and tried to enter the Exec mode:
SWITCH> enable
Password:

How do we get rid off this password, we were confused now!

Greetings, Rainer

 

[EmuDan]

It looks like the default password should be "cisco":

http://www-947.ibm.com/support/entry/portal/docdisplay?brand=5000008&lndocid=MIGR-5081383

Dan

 

[xunil321]

SOLVED!
Perfect, Dan
THX, Rainer