Cisco 2950 and MRTG

[junior238]

I currently use MRTG to graph all of the interfaces on some of the switches here, but would like to create a couple of graphs that only show collisions on a couple of ports. Has anyone tried to use MRTG to graph collisions on the gigabit ports of a 2950G?

 

[baddos]

How are you getting collisions on your gig ports? It is my understanding the that gigabit ethernet standard only supports full duplex operation.

 

[junior238]

I am using gigastack modules in the gig ports to stack the switches. When you use these modules they are running at 1000-half.

 

[BuckWeet]

It depends on how you're using those modules, if you use both ports on the GBIC, then yes they go to 1000-Half, if you use just 1, they run at 1000-Full..


BuckWeet