WanderingSailor
IS-IT--Management
Is there a global command to enable all 48 ports on a Cisco 2948G at the same time?
Thanks!
Thanks!
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Cisco 2948G - Enabling Ports
- Thread starter WanderingSailor
- Start date
- Status
Hi,
Im not sure if it will work on the 2948G but the command is
(In conf t Mode)
int range fa0/1 - 5
This will configure ports 1,2,3,4 and 5
If you want specific ports eg port 1 and 5 the command is
int range fa0/1 , fa0/5
This will only configure the 2 ports.
Im not sure if it will work on the 2948G but the command is
(In conf t Mode)
int range fa0/1 - 5
This will configure ports 1,2,3,4 and 5
If you want specific ports eg port 1 and 5 the command is
int range fa0/1 , fa0/5
This will only configure the 2 ports.
- Status