cisco 2811 router question

[emmitt2727]

I have a customer with a 2811 router at a remote site. All the phones are connectteed to this router. The call manager software lives in another building. They are trying to set up external paging on an fxo port. Does anyone know how to configure this? It is going into a valcom 2001 page control unit that needs a 600 ohm signal. Can this be done and what is the config for it?

Thanks for any help
Shawn

 

[jeter]

If you are using MGCP you can use the fxo port as a gateway and access it via a route pattern to the paging device...

Are you setup for SRST on the remote router?

If so make a dial-peer for H.323 mode in standby for paging.


SPC NVARNG
Tek-TIP Member 19,650