Hi
I have a CISCO 2811 Router with a Dual Serial Interface Card. We have 2 E1's connected bundled under MLPPP
Looking at sh interfaces output each Serial interface appears to be running at 1,544 T1 Speed ?
Reading up it apears that the controller hasnt been specified as a E1 ?
No where in the config does it say wether e1 or t1 ? is there a way to check what it is ?
Next question is if i set the card type and controller types to E1 now will this cause any issue ? as this is a live router
Any help would be appreciated
Dave
I have a CISCO 2811 Router with a Dual Serial Interface Card. We have 2 E1's connected bundled under MLPPP
Looking at sh interfaces output each Serial interface appears to be running at 1,544 T1 Speed ?
Reading up it apears that the controller hasnt been specified as a E1 ?
No where in the config does it say wether e1 or t1 ? is there a way to check what it is ?
Next question is if i set the card type and controller types to E1 now will this cause any issue ? as this is a live router
Any help would be appreciated
Dave