cisco 2611 router

[jebigham]

I have a new cisco 2611 router that im trying to setup as a
gateway

It let me setup one of the interfaces during initial boot

but i still need to setup the 2nd interface and tell them to talk to each other and to the internet firewall

Its been way too long since i've done this

can someone lend me a hand or atleast a good command refrence

thanks

 

[TMJ9779]

you will have to configure them from the command line,
en
conf t
int type/slot/number
ip address subnet mask
where is the firewall going to be located, off of what subnet?

 

[TMJ9779]

you will have to configure them from the command line,
en
conf t
int type/slot/number
ip address subnet mask
The interfaces will talk because the interfaces are directly connected networks, and what protocol are u using and where is the firewall going to be located, off of what subnet?