while i was resetting a 2600 router i belive i accidentaly typed in "confreg 0x2124" instead of "confreg 0x2142" now... when i am connected to it threw HyperTerminal all i seem to get in respons is Gyberish and not a way to type or communicate to the router... if any one can help me i would greatly appriciate it... i'm hoping i didn't FRACK the thing up....
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations gkittelson on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
cisco 2600
- Thread starter curtisbob
- Start date
You can reset it by jumpering pins 1 and 2 (left and center, when looking from the front of the router) on J2, AKA the DUART reset. This resets it to 2102.
/
tim@tim-laptop ~ $ sudo apt-get install windows
Reading package lists... Done
Building dependency tree
Reading state information... Done
E: Couldn't find package windows...Thank Goodness!
/
tim@tim-laptop ~ $ sudo apt-get install windows
Reading package lists... Done
Building dependency tree
Reading state information... Done
E: Couldn't find package windows...Thank Goodness!
- Status