Hi all
I have a client who has a Cisco 2600 router. There ISP has asked us to replace the router with another 2600 and have sent this to me in post. The only difference being that the new router has a bri0/0 interface card installed for ISDN backup. Apart from the IOS being a later version the config is identical to the old router. I have full access to both routers.
I switched the routers as requested, but i'm having problems getting eth0/0 to come up. If i do a constant ping on eth0/0 when i make the switch i get between 10-20 replies and then it goes down. To test this i just plugged eth0/0 into LAN and i got constant ping, but as soon as i plug serial0/0 in then eth0/0 goes down.
Does anyone have any ideas?
Thanks
Here is the config for the new router:
Ruder_Finn#sh conf
Using 2246 out of 29688 bytes
!
version 12.1
service timestamps debug uptime
service timestamps log uptime
no service password-encryption
!
hostname xxxxxxx
!
logging buffered 4096 debugging
no logging console
no logging monitor
enable secret
!
memory-size iomem 12
clock summer-time GMT recurring
ip subnet-zero
ip cef
no ip finger
no ip domain-lookup
ip name-server 212.111.x.x
ip name-server 212.111.x.x
!
no ip bootp server
isdn switch-type basic-net3
!
interface Ethernet0/0
description
ip address 213.219.54.x 255.255.255.x
!
interface Serial0/0
description
bandwidth 2048
backup delay 30 180
backup interface Dialer1
ip address 213.219.46.x 255.255.255.x
no ip mroute-cache
no fair-queue
!
interface BRI0/0
no ip address
I have a client who has a Cisco 2600 router. There ISP has asked us to replace the router with another 2600 and have sent this to me in post. The only difference being that the new router has a bri0/0 interface card installed for ISDN backup. Apart from the IOS being a later version the config is identical to the old router. I have full access to both routers.
I switched the routers as requested, but i'm having problems getting eth0/0 to come up. If i do a constant ping on eth0/0 when i make the switch i get between 10-20 replies and then it goes down. To test this i just plugged eth0/0 into LAN and i got constant ping, but as soon as i plug serial0/0 in then eth0/0 goes down.
Does anyone have any ideas?
Thanks
Here is the config for the new router:
Ruder_Finn#sh conf
Using 2246 out of 29688 bytes
!
version 12.1
service timestamps debug uptime
service timestamps log uptime
no service password-encryption
!
hostname xxxxxxx
!
logging buffered 4096 debugging
no logging console
no logging monitor
enable secret
!
memory-size iomem 12
clock summer-time GMT recurring
ip subnet-zero
ip cef
no ip finger
no ip domain-lookup
ip name-server 212.111.x.x
ip name-server 212.111.x.x
!
no ip bootp server
isdn switch-type basic-net3
!
interface Ethernet0/0
description
ip address 213.219.54.x 255.255.255.x
!
interface Serial0/0
description
bandwidth 2048
backup delay 30 180
backup interface Dialer1
ip address 213.219.46.x 255.255.255.x
no ip mroute-cache
no fair-queue
!
interface BRI0/0
no ip address
