CISCO 2600 series Lost configuration

[panathinaikos]

Hello

We have a Cisco 2600 series router and we lost configuration. Router is blank(no name no interfaces address nothing). Is any way to find it and reload it. I tried Copy flash command but it says Not enough memory on the disk.
As it is an urgent situation I will appreciate any help

Thank you

 

[imbadatthis]

do a dir flash:

and see whats in there.

there is a very very strong possibility that your flash is fried...

although it could just be lots of dust.

so i guess what im trying to say is:
1) do a dir flash:
see whats in there , if there are lot of files (no space) delete some and take it from there.
2)(have you done this step yet? if yes go to step3, if no continue):
if that dont work, you keep getting errors,
turn router off.
take the top off.
clean it out (properly and be very cautious)
clean your ram and flash .
put everything back where you found them.
turn it back on and go to step 1.

3)all else fails, buy new flash

http://www.ebay.ca/sch/i.html?_from...w=cisco+2600+flash+&_sacat=See-All-Categories

make tftp server
hope to god you can read your flash enough to copy existing config to tftp server
copy to tftp server
replace flash .
copy from tftp to flash .


We must go always forward, not backward
always up, not down and always twirling twirling towards infinity.

 

[vipergg]

Please post a show version and a dir flash: .