Hi. I'm trying to add a route to access another network over my WAN. (Add the two wan's to make one wan) Here's the setup.
WAN 1
Site A - Cisco 2600 @192.168.42.240 ---> Site B Cisco 2600 @192.168.100.240 --->Site C 2600 @151.128.1.240
WAN 2
At site C there is also a Cisco 1600 @ 151.128.1.254 ---> Site D Cisco 1600 @ 192.168.45.254
Both the 1600 and 2600 routers at site C are connected via switch and can see eachother.
I can communicate from between sites A and C and from C to D but not from A to D. What do I need to do to fix this.
The routers are on WAN 1 are using EIGRP but not on WAN 2 if it makes a difference.
Thanks in advance.
WAN 1
Site A - Cisco 2600 @192.168.42.240 ---> Site B Cisco 2600 @192.168.100.240 --->Site C 2600 @151.128.1.240
WAN 2
At site C there is also a Cisco 1600 @ 151.128.1.254 ---> Site D Cisco 1600 @ 192.168.45.254
Both the 1600 and 2600 routers at site C are connected via switch and can see eachother.
I can communicate from between sites A and C and from C to D but not from A to D. What do I need to do to fix this.
The routers are on WAN 1 are using EIGRP but not on WAN 2 if it makes a difference.
Thanks in advance.