Cisco 2513 Routers

[rlgaooa]

I recently aquired two Cisco 2513 routers. I am attempting to upgrade the IOS and am having the following problem. The routers are 2513, 16384 KBMemory. System flash memory partition 1 contains 8192K with image C2500-js-l.112-17.P.bin and system flash memory partition 2 8192K contains image C2500-js-l.112-26.P4.bin. When I attempt to load the basic IOS 12.3 for the 2500 series I get an error that the image is larger than the partition and the previous image is not deleted. Is there a flash upgrade available for these routers? Do I have to delete the image on partition 2 before installing the new ios? What is the newest image I can load onto these routers?

 

[chipk]

You can undo the partitioning. It isn't a problem to erase your flash as long as you don't reboot your router before you create one partition and tftp the new IOS over, following the upgrade procedures, of course:

http://www.cisco.com/warp/public/130/sw_upgrade_proc_flash.shtml

http://www.cisco.com/univercd/cc/td...s122/122sup/122csum/csum1/122csfun/fsf009.htm

no partition flash-filesystem:

 

[GFROSTY]

I have the same issue as rlgaooa.
I recently bought 4 2500 series routers to start my ccna training, but 2 of then have the flash banks partitioned as 1 and 2.

i have 16mb dram and 16mb Flash (2x8mb) in all the routers.
some are intel flash and others are mixed.

i have tried to remove the partition with 'no partition flash' but I get this error..

================================================
Configuration register is 0x2101

Router(boot)# no partition flash
^
% Invalid input detected at '^' marker.
==================================================

Any ideas????. here is a show ver of my 2503

=======================================
show ver
Cisco Internetwork Operating System Software
IOS (tm) 3000 Bootstrap Software (IGS-RXBOOT), Version 10.2(5), RELEASE SOFTWARE (fc1)
Copyright (c) 1986-1995 by cisco Systems, Inc.
Compiled Thu 23-Mar-95 02:08 by kmac
Image text-base: 0x01020000, data-base: 0x00001000

ROM: System Bootstrap, Version 5.2(5), RELEASE SOFTWARE

Router uptime is 1 minute
System restarted by reload
Running default software

cisco 2500 (68030) processor (revision D) with 16380K/2048K bytes of memory.
Processor board serial number 02089090
X.25 software, Version 2.0, NET2, BFE and GOSIP compliant.
ISDN software, Version 1.0.
Authorized for Enterprise software set. (0x0)
1 Ethernet/IEEE 802.3 interface.
2 Serial network interfaces.
1 ISDN Basic Rate interface.
32K bytes of non-volatile configuration memory.
8192K bytes of processor board System flash partition 1 (Read/Write)
8192K bytes of processor board System flash partition 2 (Read/Write)
--More--  
Configuration register is 0x2101

Router(boot)>
==================================================

 

[GFROSTY]

doh, ok sorted it... forgot to do the no partition flash command from conf terminal... back to the cbt...