Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Cisco 1841 Bonded T1 Help

Status
Not open for further replies.

IAMBILLGATES

IS-IT--Management
Oct 1, 2012
3
US
I have more questions on the bonding of the T1's.
Is the S0/0 and S0/1 really set to no ip address or do I put in the IP addresses?
Interface already configured. How would it look after referenced thread configuration with the below setup.
interface Serial0/0/0
description connection to {Provider}
ip address 123.123.123.123 255.255.255.252
ip nat outside
no fair-queue
service-module t1
timeslots 1-24
How do you know if they are using PPP Multilink or not? The provider said they are not doing load balancing.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top