Cisco 1800 Router from PC to WAN not able to ping 1

[AtharvaNaresh]

Hi,

Can any one help me. My problem in I can ping from the ROUTER to wan,lan port and pc. But from the pc I am not able to ping WAN. But i can ping lan port of the router. Please find the attach ment of the router config.

LAN : 192.168.0/24
LAN IP: 192.168.0.64
WAN : 192.168.169.0/24
WAN IP: 192.168.169.174

Regards
My Router config.
----------
no ip domain lookup
!
!
!
!
interface FastEthernet0/0
ip address 192.168.169.174 255.255.255.0
ip nat outside
speed auto
full-duplex
no mop enabled
!
interface FastEthernet0/1
ip address 192.168.0.64 255.255.255.0
ip nat inside
speed auto
full-duplex
no mop enabled
!
router rip
redistribute connected
network 192.168.0.0
network 192.168.169.0
!
ip classless
ip route 0.0.0.0 0.0.0.0 FastEthernet0/1
ip route 192.168.0.0 255.255.255.0 192.168.169.252
ip route 192.168.169.0 255.255.255.0 FastEthernet0/1
!
ip http server
!
access-list 1 permit 0.0.0.0 255.255.255.0
dialer-list 1 protocol ip permit
!
control-plane
!
!
line con 0
line aux 0
line vty 0 4
password cisco1
login
!
end
---------------------------

 

[dgrizzard]

You have a couple of things wrong in your config, but before that... is there a DSL or other connection on the f0/0 port?

 

[AtharvaNaresh]

No other connection let me explain.

I want to connect my sisterconcern office. they are in 192.168.169.0/24 and our office is 192.168.0.0/24. My Wan port is configure with 192.168.169.174 and Lan port is configured with 192.168.0.64. I want to access both side computers. Please help me. thanks

 

[AtharvaNaresh]

Sinerio is like this.

OfficeA-(3comBridge)<-->(Bridge)--->(Cisco1800)-->OfficeB
3comBridge = IP :192.168.169.252
3ComBridge = IP :192.168.169.254
Cisco1800 Wan= IP: 192.168.169.174 LAN :192.168.0.64

OfficeB= is in 192.168.0/24


thanks

 

[hammnet]

1. Make sure your end hosts have a default gateway of the router interface on the local subnet.

2. Your ip route statement to the 192.168.169.0 network should point to fastethernet 0/0

3. Your ip route statement to 192.168.0.0 network should point to fastethernet 0/1

3. You don't need the static routes AND rip routing. You can use one or the other.



CCNP, CCNA Voice

 

[sannithi]

what hammnet said is true. If your purpose is to reach only these 2 subets, you can even remove default route also...

No need of static routes.. It will follow correct interface based on ip configured ....