Cisco 1710 NAT

[crs4]

I have a web server on my network that has users that connect over VPN using the built-in VPN module. The problem is that the remote network and the local network both have the 192.168.0.0 ip scheme and therefore the remote nets cannot access the web server. I put in a static NAT translation but it's still not working.
Here is what I entered:
ip nat inside source static <remote VPN Pool IP> <local web server IP> extendable no-payload(in case it was translating embedded port/IP info since it's a crypto tunnel.) I still am having no luck....any ideas?

Thanks,
Charlie

 

[pmesjar]

maybe this can help

http://www.cisco.com/univercd/cc/td/doc/product/software/ios122/122newft/122t/122t13/ftipsnat.htm

Peter Mesjar
CCNP, A+ certified
pmesjar@centrum.sk

"The only true wisdom is in knowing you know nothing.

 

[gconnect]

it sounds like you need to use the "outside source" command instead of the inside source command

http://www.cisco.com/en/US/tech/tk648/tk361/technologies_configuration_example09186a0080093f30.shtml

-gC-

 

[crs4]

Even though it's travelling through a VPN tunnel which logically is an "inside" trusted source?