CID on a PRI/T1 Trunk

[TriniTech87]

Hi Guys

I have created a PRI/T1 circuit to my services provider
But.............. They want to see my CID on their system
Via programming change public-unknown-numbering they can see what I have programmed but their engineer is say that they can not see any digits being dialed on my end

Note the SIG and Trunk Group are all up and working btw

 

[joe2938]

what does the trunk group programming look like, not much to go on here

 

[7deedtz]

Trunk Group Option for Outgoing Display should be enabled, Check also on System options if anything to do with Outbound CLI

Thank you