Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

CICS Programming Issue

Status
Not open for further replies.

TELEQ

Vendor
Jun 16, 2008
2
Hi,

We are installing a MoH for a customer, however, when we go into system programming the feature tree isn't available... we cannot locate where to enable the BGM or MoH.... The software is Rls 1.0 - we have never come across this problem before - has anyone else?
 
for a 1.0 software check out
4. call handeling: On hold:music
and
5. Miscellaneous: Background music: Y

Check the FAQ's for wiring location.

----------------------------
'Rule 29', "The enemy of my enemy is my enemy's enemy. No more. No less."
----------------------------
JerryReeve
Communication Systems Int'l
com-sys.com

 
Thanks Jerry we will give that a try...
 
you may also need to install a resistor in series with the MOH source to match the impedence. The symptom that indicates a need for this is when the music volume oscillates up and down.
 
I think 1.0 is still Terminals&Sets, etc...not A.Config, etc... Correct me if I'm wrong.

Should be under Sys Programming/Feature settings.
 
3x8, 6x16, 8x24 and all MICS lower than MICS 2.0 start with A. Config.

All CICS versions, and MICS 2.0 and higher start with Terminals&Sets.

Just an FYI...
 
Thanks, DBrewsky. We don't have many out there with sw that old out there. A couple MICS r1t1, but that's about it.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top