CICS make 4 lines appr & ring on 7208

[steamup]

An existing CICS installation with no documention or user knowledge.
I have added a 7208 to previously vacant port 27 that apparently had been config for a 7316 in an earlier life. No buttons show lines.
How can I make co lines 1,2,3,4 appr and ring on this 7208?

Thank you for any help

JW

 

[curlycord]

Sorry but cant trian a user on a forum when it takes a week in person.

Suggest you call a vendor in to do this since its on techs side of programming.

Otherwise its in TermsSets/XXX/LineAccess/LineAssignment.

I do suggest you gets guides as you said you have none......kinda of pointless without them?



=----(((((((((()----=
curlycord

http://www.curlycord.com

 

[steamup]

Apology - I did not explain clearly
I am Vendor-
'User' has no documentation, programming record, or user knowledge....an inherited sys installation.

7208 has moved internally to an abandoned port - 27.
27 apparently was hosting a 16 button set. [I connect a 7316 and it shows f codes on 16 buttons]

I need line 1,2,3,4 to appr & ring on the 7208 buttons at port 27

can I copy set/user that has lines 1,2,3,4 on buttons?
[doing homework tonight for on-site tomorrow]

Thank you for help

JW

 

[notme11]

as curly said above you need to log into system if you are a vendor you can do that with the admin password. thsn go to terminals and sets , line access, line assingment, that will do the trick. you dont need the old records to get this far.

 

[curlycord]

You need Config password for line assignments, Admin wont allow line assigments, yes set copy works too.

=----(((((((((()----=
curlycord

http://www.curlycord.com