Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

CICS 8-Port Expansion Card

Status
Not open for further replies.

MooreTel

Programmer
Dec 12, 2014
211
CA
I ordered some of these and what I got were NTBB04GE. When installed the system won't boot up. After looking closer at the card, I see that there are fiber contacts and the label says "CICS FIBER/CLOCK CONTROL GEN.

What are these used for as I've never used them?
 

You can use these cards and add a fiber 0x16 module which you will get 8 extensions out of.

We've done this as a cheaper solution that buying the normal NTBB04 cards.

I believe these fiber cards also provide clocking for ISDN.
 
What software on the CICS? You may have to do a cold startup.

Marv ccna
telemarvlogosmall.gif

Sales, Installation & Service for Norstar, BCM, Samsung & Allworx Serving Ottawa and Eastern Ontario since 1990
 
Marv: I've got 4.2 on the bench. I believe they're 6.1 if I remember right.

Numberonetelecom: You're right. Just connected via a fiber 0x16 and got ext's 257-264 on the 1st 8 ports. After that they just flash.

exsmogger: Can't say for sure as the only NAM I have here is copper, but don't see why not.


Guess I'm going to have to modify this quote if the supplier won't change them...

Thanks everyone.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top