Chg of call park digit

[ringbacktone]

I am in process of installing a new MICS. Current system has a numbering plan using 1,2,4,5,6 and 700 numbers.Since there were only 8 100 numbers I started DN numbers
at 200. The digit 3 is being used for the 300 numbers assigned by the system. These numbers are on non existing station modules. I suppose i can chg 300 to an unused
100 number, 301 also to a 100 number right down the line till I run out of 100 numbers to use. Then I can start on the 200 range till all 300 numbers are changed.

It just seems there is a better way. I tried to strong arm the user but she is cute.
If any one on this forum can offer any better way I greatly appreciate it.

Thanks in advance,

RBT

 

[exsmogger]

What about using 4-digit DN's? That should open up some digits in the numbering plan.

Brian Cox
Georgia Telephone

http://Georgia-Telephone.com

http://www.linkedin.com/in/briancox1952

 

[ringbacktone]

The whole deal revolves around buisness cards with 3 digit numbers on them. I suppose that changing all of the 300's would probably take 30/45 min.
If I do not get some way to do it from forum I will just do that. To have a numbering plan like this is nuts.
Thanks

 

[allworxguy]

You can do a STARTUP AND SELECT 100 as the starting DN.

Marv ccna

http://www.telemarv.ca

Sales, Installation & Service for Norstar, BCM, Samsung & Allworx Serving Ottawa and Eastern Ontario since 1990

 

[ringbacktone]

I have already entered key codes for PRI so I am reluctant to do startup. I guess I will just change all 300 numbers to something else.
Thanks

 

[allworxguy]

Don't forget if using a Call Pilot you have to adjust the NAME AND SPECIAL PREFIX for 100 range of DN's.
Link

Marv ccna

http://www.telemarv.ca

Sales, Installation & Service for Norstar, BCM, Samsung & Allworx Serving Ottawa and Eastern Ontario since 1990

 

[ringbacktone]

Thanks Telemarv, I do remember having this issue before now that you mention it. I think I must have used all my ram,

Have a great day

 

[ringbacktone]

Telemarv, Would you mind sharing what I need to do to vm? I do not remember the details.
Thanks very much

RBT

 

[curlycord]

What are all your digits used for?
i.e. we see from your posts that 1 and 2 are probably DN's but the rest your are not clear on at all.

"The digit 3 is being used for the 300 numbers assigned by the system"
What does that mean?
Do you mean to say 3 is used for DN's as well?.


=----(((((((((()----=
curlycord

http://www.curlycord.com

Toronto Canada

http://www.telcopc.ca

 

[allworxguy]

Read this FAQ

http://www.tek-tips.com/faqs.cfm?fid=4937

Marv ccna

http://www.telemarv.ca

Sales, Installation & Service for Norstar, BCM, Samsung & Allworx Serving Ottawa and Eastern Ontario since 1990