Check run going wonky...

[thamink]

I have a problem with Great Plains Dynamics and my check runs. It's kinda weird. I could print out one check all day long with no mistakes. Around about a half a dozen or more, it's a little more problematic. (this is all of a sudden by the way) What will happen is that the checks will start printing wrong. Wrong check number, won't print the top stub and print the middle stub where the top stub should be and the bottom stub where the middle should be.

After it starts the wonkyness, it keeps going until I cancel the print run. It's bad news. It NEVER happens with one or two checks. Only on larger check runs. I am miffed. Anyone?

 

[stef315]

Are you using a modified check?

I think the primary key on the report could have been changed.