Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

check printer

Status
Not open for further replies.

joebit

MIS
Feb 21, 2008
17
AU
All can anybody tell me how to get rid of the flashing check printer alert on the main handset of a td1232 system. I've been trying to connect my laptop to the system with no luck. I initially changed the outgoing signal to all in program mode 800. Have changed it back to off again but the alert remains.

regards

Joe
 
nener heard of check printer error what Country are you in
what type of printer are you connecting?
 
I'm located in Australia and the funny thing is that I'm not trying to connect to a printer. I was trying to connect to my laptop but don't have the correct null modem cable
 
Once I got the correct cable up and running I connected to the PABX through hyperterminal and presto the system started spitting out all the calls that were made during the time that I had program mode 800 set to on. No more check printer flashing sign on the main hand set.
 
that check printer thing ust be on the oz system
ours just buffers calls untill you connect.
 
How long does it buffer the call records for?? I think ours stops at 100. So if its a busy system our check printer alarm is a good thing...better to know there is a problem and fix it rather than lose some of that call data.
 
Of course, the Mitels just stopped routing calls when the SMDR buffer filled up :)

Panasonics buffer some number of calls, maybe 8K bytes or something like that, then overwrite the oldest calls. The alarm thing may be an option.

LkEErie
 
you also get check printer here in the euro zone
in your case your getting this error because the printer is trying to print your call log with no printer attached you most likly switched this on when trying to setup your laptop!! the printer option is not required unless your using call logging

in the euro zone systems this is in prog NO 800 if you can find the printer option on your system set to disable this will stop the error.


peter (
 
there is also prog 802 you may have started the system data dump make sure this is also off

if the port is still open then reset the system.



peter (
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top