Channels in MBSY

[atascoman]

I am trying to get TIE trunks working between two sites. The T1 is being routed over a sonet ring controlled by Optera M3500 equipment. The spans on both ends will establish with a DTA023 and the D-channel will establish, but all the channels stay in MBSY.

Shortly after the DCH establishes, it sends a EST TIMER REC message and will occaisonally drop but comes back. During all of the the channels remain in MBSY on both ends.

Any ideas?

 

[PERRYPJ]

YOU STILL HAVE SOMETHING WRONG WITH THE DCH WHAT'S AT THE OTHER END OF THE NORTEL

OLD ROLMEN WORKING ON NORTELS

 

[senk1s]

try and do a complete disable/enable sequence at both the PBXs
maybe thats all that is required.

match the settings of the csu on both ends

 

[atascoman]

Thanks yall. I found the problem to be the Optera equipment was set to D4/AMI and my end was ESF/B8ZS. Not being familiar with how to configure the Optera units slowed me abit.