Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Changing the number on a meridian set??

Status
Not open for further replies.

Raedeke

IS-IT--Management
Mar 22, 2004
13
US
I have a Norstar Meridian system. I have about 50 DID numbers available to me, and need to change the number on one of my phone sets from it's current non-DID number to one of my avialable DID numbers. I can assign a line to the number and name the line and the set, but am having trouble assigning a specific line to a set - I'm assuming I need to know which port it's on and have not seen that in the config or admin areas... any help is very much appreciated.
 
You may want to try the norstar forum, you may get more response

OLD ROLMEN WORKING ON NORTELS
 
You would be best to place this question in the Norstar section of this web site. I seem to remember that the DID entries were found under the "Line Access" section of "Config". It's been a few years since I played with Norstars.

All the best

Firebird Scrambler
Meridian Programmer in the UK
 
Thanks - I'll try over their.
Thanks very much.
Cheers.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top