Changing the IP in the C-LAN BCM 400 4.0

[sienz]

I need to change the IP address in our BCM. We dont use IP phones so I thing it does not really matter i guess If i need to change the IP address. Can someone confirm it?

NIC: eth0 is the ip address which i need to access to use the element manager from my PC, Is this the C-LAN?

NIC: eth0
IP 10.21.3.138
Mask 255.255.255.224
MAC
NIC: eth1
IP 10.10.11.10
Mask 255.255.255.0
MAC

Is there anything that I should concern about it?

So I need to bring Crossover cable with laptop and access it on NIC: eth1 to change the IP address on NIC: eth0?

Where can i find the field in the element manager to change the IP address for NIC: eth0?

Thank you

 

[Dasheen]

Do u have CC Reporting? If so u'll need to changing the BCM IP there too.

Connect to BCM via LAN 1 or LAN 2. Look for Network Interfaces and change the IP for the LAN port u have connected to your network.

 

[sienz]

No I dont have the reporting installed. Do i need to use crossover cable to connect directly to the PBX?

Thanks

 

[bluemr2]

Yes, if you connect directly you will need a crossover.

 

[sienz]

Do we need to reboot the PBX after we change the IP?

 

[Dasheen]

I don't think so but it'll tell u if u need to.

 

[sienz]

My vendor tech also told me that i do not have to reboot it.

But yes, you will need to reboot it otherwise the IVR and Callpilot would not work. It will tell you when you change the IP.