Changing the DES for a channel on a T-1

[rmbbikes]

I have noticed that none of my loops are labeled. I would like to label them using DES label one channel with the loaction and another channel with the circuit ID.

I will go into ld 60 and dsch XX XX then I would like to relabel.

What ld do I use to accomplish this?

Thanks,
Keith

 

[johnpoole]

in load 14 under des for the tns, the name you see when you see that route inbound can be changed in 95.. the acod of the rdb will take a name just as a station dn...

john poole
bellsouth business
columbia,sc

 

[wdhb]

you can label as follows

LD14 trunk DES of up to 16 characters
LD16 route DES of up to 16 characters
LD17 d-ch DES of up to 16 characters

DES does not display in LD60 even if the above is done. DES shows in LD96 for d-ch & LD21 if you PRT the route or LTM

 

[rmbbikes]

Thank you. That's what I was looking for. I wanted to rename a channel so I could use it as an ID not so much for call routing ID.

Thanks again!!

KB