Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Changing PRI parameters on CS1K

Status
Not open for further replies.

alishbee

ISP
Apr 5, 2006
5
GB
I am trying to integrate Asterisk with CS1K through a PRI. I need to change switch type but it is not allowing me to do that. Is it possible to change PRI parameters of already configured ADAN and RDB? or I have to follow some other procedure. I would really appreciate your help in this regard.
 
You will more than likely need to out the trunks and route before modifying the d-channel programming then build them back. I would also out the d-channel instead of modifying it.
 
That is sometimes the only thing you can't change. If you are at NI2 or need to go to NI2 from ESS5, D100, etc.. as stated, you will need to out everything and put back in.

John Anaya
Signet6 Network Sciences
ACSS/ACIS - CS1000 Rls 7.5/Call Pilot 5
ACSS/ACIS - SME - IP Office 8.0
APSS/APDS - Avaya UC Services

Public Profile
 
Thanks for your replies. I have to out and rebuild following

PRI Loop
DCH
RDB
BCH
RLI
CDP

But there are some other routes and Adan configured for h.323 trubk pointing to another switch. Do I have to out those too and rebuild or I can do it without touching other stuff? I would appreciate if you tell me sequence to out them and sequence to build them with corresponding loads.
 
Thanks for your replies. I am wondering somebody would be able to provide help in this regard. I am willing to pay for work hours. Please let me know if if somebody is interested.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top