Changing out a Dual SDI Paddle Board to a Quad SDI Paddle Board Procedure.

[dogg1]

Hi All,

Just looking for a little confirmation on the steps to swap out an SDI card. I'm moving from a Dual to a Quad SDI Paddle Board. Here are the steps if I remember correctly:

LD 37
Dis tty 2 and 3(TTY 2 is the XSM)
Hard ware disable the Dual SDI Paddle Board and Remove.

Fuzzy Part:Do I need to out those TTY's before I seat the New Quad SDI Paddle Board in the PBX or can I do this after I put in the new card?

LD 37

enl tty 0(new XSM tty)
enl tty 1(replaces tty 3)

Dip switches on the new SDI Card are already configured .

Thanks for the help!

 

[KCFLHRC]

I would disable them, out them, install new board and rebuild them and then enable them.

 

[KCFLHRC]

Are you going to be using the additional 2 ports on the Quad card?

 

[dogg1]

I don't need to remove the system monitor card though, corret?

 

[KCFLHRC]

Correct, just disable that tty port for the system monitor

 

[dogg1]

one last question.

One of those TTY's that I have to disable and out is the TTY for the XSM. Will outing the TTY for the XSM be an issue?

Thanks for your help, much appreciated.

 

[KCFLHRC]

No, it will not be an issue. Just build it back when you are done and then do a STAT XSM in LD 37 and make sure it returns PWR000

 

[KCFLHRC]

PWR000 for all columns.