changing from t-1 to pri 1

[fonegal]

Service provider no longer supporting old T-1 service and has requested customer convert to Pri service. I am aware that the expansion module does not require key code on Their BCM 50 Version 2.1 but would I now need to redo DID's and reassign out going pools to each phone?

 

[cook1082]

Just change the card to PRI NI-2 BAZS. Remove pool codes and make Destination code of 9 and point it to route 001 it should use PRI A or B. The targets will stay the same. Then each phone will need access to PRI a/b.

 

[fonegal]

Thanks cook but I also thought I remember something about Bloc a or b on a PRI ?

 

[getsomesun1]

You are correct. Block or B. Everything else Cook says is correct.