changing Framing on Tie Line 1

[rlong411]

I need to change the framing on one of my loops and I am not possitive how to. Can anyone give some assistance?

Current framing is D4/AMI/DG2 and I need it to be B8ZS/ESF
Please Help!!!

 

[johnpoole]

is it pri or t1?

ld 96 dis dch x auto

ld 60
disl x

ld 14
out 23

ld 16
out
rdb

ld 17
chg
adan
out dch x

ld 17
chg
cequ

then x plus the loop number

then go back through and put it back in in the same order.. sounds like a lot of steps but it's about 30 minutes to turn one over..

john poole
bellsouth business
columbia,sc

 

[penduko]

john poole was right, if you are using DTI you can do the steps below:

ld 14
out 24
tn x x <<------ the TN of the trunks

ld 60
.disl x <<---- loop of NTAK09

ld 17
chg
cequ
DLOP xL 24 d4 <<--- this will delete the L (Loop)
DLOP L 24 EST <<--- this will create a T1 loop with ESF framing
LCMT B8ZS


The next step is to re-create the trunks in LD 14
The last step is to enable the loop in LD 60 (ENLL x)


Hope this helps

 

[teekow]

Don't forget about the dipswitches. I remember converting a T1 with SF/AMI to a PRI with ESF/B8ZS and I had to manually change dipswitches on the card as well as the programming already described.

I don't remember the switch settings.

hope this helps
Rob

 

[johnpoole]

there is one switch to change, good catch

john poole
bellsouth business
columbia,sc