Changing Equipment

[TelcomATSS]

Changing sets from 2008/2616 to new M3903/3904. Is there an easy way changing equipment types ? Then going back and changing the keys.

Right now, I just "out" the set then "add" the new set.

Opt 61C with OTM.

Thanks,

 

[johnpoole]

you can use script files in procomm, but they do the same thing, a type change is a rolm feature, but has never been included in the sl1 software

john poole
bellsouth business
columbia,sc

 

[mikeyb123]

be careful, we put in some 3904's and it ini'd the loop.

make sure you out the old config, remove phone, plug new in, thn configure.

we lost a shelf's worth of calls........

It's not getting any smarter out there. You have to come to terms with stupidity, and make it work for you.

 

[johnpoole]

that is common with the newer rls if the software and the phone are a mismatch.. very bad if you program 3900's and then don't change the 2000 series phone... had a user that was changing out a card at a time, out the old build the 3900's and then walk to the sets... that "tech" no longer works at that site...the ipe does a restart, then when it does a sdl 100... it restarts again...

john poole
bellsouth business
columbia,sc

 

[johnpoole]

btw... to prep for a upgrade i ran a ld 117 inv generate sets... pulled it up in excel and had it compare software with chipset... 70 bad out of 6000, not that bad but i am glad i didn't upgrade with that... some of my rebuilt 2616's had 2008 chip sets.. some had serial number ffffff.. now this cust uses Bell South as a single source provider, it's a little costly to replace 70 working sets.. which is what they are doing

john poole
bellsouth business
columbia,sc