Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations IamaSherpa on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Changing Default Priority from 500...
- Thread starter Krusher
- Start date
I don't know of a way to set a new default for the task priority. The programmed default is 500 except for recurring tasks where it is 1000. (In P98 the priorities are descriptors like "very high", "high", "very low", etc. -- about 7 or 8 of them.)
You could display the Priority column, set the field on the first line to 0 and then drag it down the remaining rows and then press Ctrl+D to distribute it.
Given that you have a range of 0-1000 and you want it to start at 0, I think I'd leave well enough alone. You still have 499 degrees of granularity - I doubt I've ever used more than 5 in a project.
You could display the Priority column, set the field on the first line to 0 and then drag it down the remaining rows and then press Ctrl+D to distribute it.
Given that you have a range of 0-1000 and you want it to start at 0, I think I'd leave well enough alone. You still have 499 degrees of granularity - I doubt I've ever used more than 5 in a project.
- Status
Similar threads
