Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Changing assigned module FCT id

Status
Not open for further replies.

LineMann

Systems Engineer
Sep 28, 2020
11
IN
Hi Everybody,
Please guide me to modify the assigned module's fct id from 2 to 1 to make it a PRI from CAS.


LTG 1 LTU 5 SRCGRP 1 ALARMNO-LTU 0
-----+-----------+--------+---+-+-+---+-+------------+------------+------------
| | | |S|H|AL-|N| | |
| ASSIGNED | MODULE |FCT|E|W|ARM|P| INSERTED | HW- | MODULE
PEN | MODULE | TYPE |ID |C|Y|NO |R| MODULE |STATE INFO | STATUS
-----+-----------+--------+---+-+-+---+-+------------+------------+------------
1 | Q2226-X200 DIUT2-E1 2 0| | Q2226-X200 | 1 -08 - | READY


It is not allowing me delete the location either so that I can add a new one.

DELETE-BCSU:MTYPE=DIU,LTG=1,LTU=5,SLOT=1;
H500: AMO BCSU STARTED
F10: MODULE LINE CIRCUITS NOT DELETED

Please help
 
You have a trunk configured already on that card - you have to 'work backwards' to remove the trunk and associated routing to bring it back to a 'bare card'.
It might be easier to provide a new card and set that up - or bring in an external tech
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top