OrtegasBistro
IS-IT--Management
I've got two older Micros P1210 terminals that were installed years ago as a part of our Aloha 5.3.28. The P1210's were set for 1024x768. Several new Micros terminals have been installed, and are 800x600. Consequently my custom button pannels are all botched up. The tables don't match up with the floor plan.
I tried to change the resolution on the new terminals to match the old, but unfortunately the only available option is to leave them at 800x600. So I've reconfigured my button panels to match that resolution.
So now the P1210's don't display the panels correctly... the tables appear in all the wrong places. (I assume that's because the panel was set up for 800x600, but is being displayed at 1024x768).)
Does anyone know how to change the screen resolution on the P1210 terminals? I assume there's some configuration setting or .ini setting somewhere, but haven't had any luck finding it.
FYI I've already tried simply going into "Display Properties" and changing it there like any other PC, but that didn't work... the panels were even worse, and the order buttons were all off too. So I changed it back.
Any help would be much appreciated!
I tried to change the resolution on the new terminals to match the old, but unfortunately the only available option is to leave them at 800x600. So I've reconfigured my button panels to match that resolution.
So now the P1210's don't display the panels correctly... the tables appear in all the wrong places. (I assume that's because the panel was set up for 800x600, but is being displayed at 1024x768).)
Does anyone know how to change the screen resolution on the P1210 terminals? I assume there's some configuration setting or .ini setting somewhere, but haven't had any luck finding it.
FYI I've already tried simply going into "Display Properties" and changing it there like any other PC, but that didn't work... the panels were even worse, and the order buttons were all off too. So I changed it back.
Any help would be much appreciated!